Pairing RF energizer with remote controller

To remotely control and monitor RF energizer fencee power DUO RF PDX , you must pair it first.

Pairing procedure

1. Switch on the energizer and then switch it off with one short press of the button. Then press the button for a long time (> 5 seconds) until the status LED flashes very quickly. The energizer is now in pairing mode.
2. Long press the Pairing button on the remote controller. The display will light up with the letter P. The controller is now in pairing mode.
3. Use the arrow keys on the keypad to select the desired position number to pair to.
4. Move the controller close to the energizers (within 20 cm) and press the P Pairing button.
5. If everything went well, you have now paired the remote controller with the energizers. The controller will switch back to the main screen and the energizer will switch back to the OFF RF state.
6. If the pairing process did not go well, perform the pairing again.
7. If you want to delete a position on the controller, perform the pairing without the energizer. If the controller does not find any energizer, it will delete the paired position.
8. To exit the pairing mode, press the red ON/OFF button.

• Up to 6 RF energizers can be paired to one remote controller - you can control 6 RF energizers with one remote controller.
• It is possible to pair up to 3 remote controllers to one RF energizers - you can control one RF energizer with 3 remote controllers.

Can't pair your devices? Contact our technical support where we will advise you.
Phone: +420 730 893 828 | E-mail: info@fencee.eu